Kenco-engineering SmartSonic Transmitter (Remote) Manuel d'utilisateur télécharger pdf (Page 30)

Page 30

ADDITIONAL FEATURES

This section describes the functions available in SmartSonic Remote's additional menu. The additional menu functions

enable you to calibrate SmartScan to perform the following tasks:

• Display Values in volume format.

• Display Values as a total accumulative value for flow.

• Calculate volume for different tank types.

• Calculate flow measurements for custom flumes.

• Calculate results in alternative measurement units.

• Adjust results when there is interference from a conical tank ending.

• Allow compensation of different types of gas.

Press / Action Display Description

Connect SmartSonic to power supply See Wiring Section

The SmartSonic takes several seconds to

warm-up. During this time various characters

will turn on and off, and the Tank Graphic will

cycle

and simultaneously

This is the password display

and

Use to enter the password (716) in place of

(000). BACK and NEXT will change the vlue of

the digit (0-9). ENT steps to the next digit; ESC

steps to the previous digit.

Single Sensor (only available option).

Flashes for 5

seconds, then is

displayed

Is now displayed

Flashes for 5

seconds

Pr 0 is now displayed.

Use BACK or NEXT to scroll through the other

menu options (described later in this section)

NOTE: Press ESC once to return to the Main Menu. Press ESC a second time to return to the normal operating mode.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36 37

Pas de commentaire

Kenco-engineering SmartSonic Transmitter (Remote) Manuel d'utilisateur Page 30