Kenco-engineering ST Series Level Gauge Manuel d'utilisateur télécharger pdf

KENCO ENGINEERING COMPANY

P.O. BOX 470426, TULSA, OK 74147-0426

PHONE: (918) 663-4406 FAX: (918) 663-4480

http://www.kenco-eng.com e-mail: [email protected]

INSTALLATION AND OPERATING INSTRUCTIONS

FOR MODEL ESP AND ST

1. INSTALL GAUGE ON TANK FLANGES, MAKING SURE TUBE HOLDERS

ARE NOT REMOVED OR ALLOWED TO SLIP DOWN DURING

INSTALLATION. BOLT GAUGE FLANGES TO MATCHING FLANGES

WITH CORRECT SIZE BOLTS FOR FLANGE SIZE USED. TIGHTEN

BOLTS ACCORDING TO THE FOLLOWING BOLT TORQUES:

FLANGE SIZE TORQUE

1”-150# 15 FT- LBS.

1 1/2” – 150# 20 FT-LBS

2”-150# 25 FT-LBS.

3”-150# 40 FT-LBS.

4”-150# 45 FT-LBS.

2. THE GAUGE SHOULD BE INSTALLED WITH VALVES. ONCE

INSTALLED, VALVES MUST BE OPENED SLOWLY SO THAT

TEMPERATURE AND PRESSURE CHANGES DO NOT BREAK THE

GLASS.

3. TO CLEAN GAUGE GLASS, CLOSE VALVES AND OPEN DRAIN PLUGS

TO DRAIN EXCESS FLUID OFF. REMOVE ALL BUT ONE OF THE

FLANGE BOLTS. LOOSEN THIS FLANGE BOLT AND ROTATE GAUGE

SO THAT THE GLASS MAY BE CLEANED OR REPLACED.

1 2

KENCO ENGINEERING COMPANY P.O. BOX 470426, TULSA, OK 74147-0426 PHONE: (918) 663-4406 FAX: (918) 663-4480 http://www.kenco-eng.com e-mail

Page 2

GLASS REPLACEMENT FOR ESP/ST LEVEL GAUGES 1. REMOVE HARP PINS FROM CLEVIS PINS ON END GAUGE. 2. CAREFULLY REMOVE TEFLON TUBE HOLDER INSERT FROM

Pas de commentaire

Kenco-engineering ST Series Level Gauge Manuel d'utilisateur