Kenco-engineering KSF Sight Flow Indicator Manuel d'utilisateur télécharger pdf (Page 4)

Use only gaskets that have been specified by the manufacturer or the supervising

engineer. Be certain that they are clean and fresh with no bumps, tears or serious

imperfections.

Using a torque wrench, tighten the fasteners in a regular pattern to avoid uneven loads

on the glass. It is necessary to torque individual fasteners in small amounts, moving

to the next fastener after each increment of torque. A maximum difference of 3 FT-

LBS. between fasteners should be maintained on larger units; there should be less on

smaller units. Continue torquing until the value recommended for the unit is attained.

1 2 3 4

Pas de commentaire

Kenco-engineering KSF Sight Flow Indicator Manuel d'utilisateur Page 4