Kenco-engineering Magna-Site Magnetic Level Gauge (MLG-D) Manuel d'utilisateur télécharger pdf

KENCO ENGINEERING COMPANY

P.O. BOX 470426, TULSA, OK 74147-0426

PHONE: (918) 663-4406 FAX: (918) 663-4480

http://www.kenco-eng.com e-mail: [email protected]

INSTALLATION PROCEDURES FOR THE SURFACE MOUNT

MAGNETIC LEVEL GAUGE (MLG-D)

1. Slip a 2” pipe flange gasket (not supplied) over float protection

housing tube and up against bottom surface of float protection

housing support ring.

2. Lower float protection housing per Item No. 6 down into tank until

flange gasket rests on top of existing 2” pipe flange.

3. Lower float assembly per Item No. 2 down into float protection

housing per Item No. 6 until bottom of magnet holder rests on top of

PVC float stop contained on PVC float rod. Note: Float should be

carefully forced down if tank contains liquid!

4. Pick up gauge housing per Item No. 1 and prepare to place on top of

float protection housing support ring. Notice that there are two 1/8”

dia. guide rods on inside of gauge housing.

5. Position magnet holder such that the north pole (red end) of magnet

is pointing toward the flag assembly side of gauge housing.

6. Align the slots in magnet holder with guide rods on inside of gauge

housing. This ensures that the magnet will always operate flags

correctly.

7. Install flange mounting studs (not supplied) to retain gauge

assembly in place.

KENCO ENGINEERING COMPANYP.O. BOX 470426, TULSA, OK 74147-0426PHONE: (918) 663-4406 FAX: (918) 663-4480http://www.kenco-eng.com e-mail: info@

Pas de commentaire

Kenco-engineering Magna-Site Magnetic Level Gauge (MLG-D) Manuel d'utilisateur